BBS Bore Bumper Installation: Getting the First Pipe Bundle Assembly Right

Need pricing, availability, or help with your application?
Steve Simpson — Joint Specialists Inc.

Phone: 936-321-3333
Email: steve@jsicoatings.com
Website: www.heatshrinksleeves.com

Coated pipe bundle with protective bumper sections ready for field work

With BBS bore bumpers, the first installation is worth a few extra minutes. Once a crew starts repeating a detail down an HDD pipe bundle, a small misunderstanding can turn into a lot of repeated work. Bring the drawing out to the pipe, look at the actual coatings and joint profiles, and get everyone working from the same example.

Review the supplied system

Identify the bumper material, specified bonding materials, and any leader-strip details. Keep the relevant instructions at the work area. Make sure the crew can distinguish the components and understands which preparation and handling requirements apply.

  • Check the coating identity and surface condition.
  • Confirm placement and orientation from the approved plan.
  • Review bonding, assembly, and release requirements.
  • Agree on the inspection record for completed installations.

Record the accepted example

Photographs of the reviewed assembly can support the work package when they identify the pipe and show the important details. They should supplement the instructions, not become an informal substitute for them.

If the coating, pipe size, or bundle arrangement changes, revisit the relevant detail before continuing. The purpose of a first-installation review is a shared understanding of this job's configuration.

Contact JSI through our pipeline coating website with the bundle drawing and construction sequence for BBS assistance.

Questions about pricing, availability, or the material for your job? Call 936-321-3333 or email steve@jsicoatings.com. Send the drawing or a few photos if you have them—we can start there.

Joint Specialists Inc. — Providing pipeline corrosion prevention solutions since 1995.

Comments