BBS Bumpers for Mixed-Diameter Pipe Bundles: Information to Gather First

Pipeline bundle with purpose-built bumper sections between coated pipes

A mixed-diameter HDD bundle needs a clear cross-section before bumper quantities can be discussed usefully. Pipe count alone leaves out the geometry that controls where coated surfaces can approach each other.

Draw the bundle as it will be pulled

List every carrier pipe and show its position in the bundle. Identify the outside diameter over the coating, rather than relying only on nominal pipe size. Include conduits or other lines that share the crossing and distinguish them from the main carriers.

A simple marked-up cross-section can reveal questions that a purchase list misses. Which pipe sits beside which? Where are the largest diameter changes? Do field joints project beyond the factory coating? Are different coating systems present in the same bundle?

Show the longitudinal details too

The cross-section is only one view. Provide the crossing length, approximate joint locations, planned staging arrangement, and pull direction. These details help frame a discussion about bumper configuration and installation planning without assuming one spacing rule will suit every bundle.

  • Pipe count and coated outside diameters.
  • A cross-section showing the intended arrangement.
  • Factory and field joint coating descriptions.
  • Crossing length, handling plan, and known contact concerns.

Keep engineering and supply questions connected

BBS bumpers are intended to help separate pipes and protect coatings during bundled installations. Their selection does not replace the engineer's review of bore clearance, pulling loads, buoyancy, or the overall bundle design. Bring the bumper discussion into that planning process early enough for the teams to exchange information.

Contact JSI with a bundle drawing and project description. You can start through Joint Specialists' pipeline coating website and include photographs of a trial assembly if one is available.

Contact Joint Specialists Inc.

For product selection assistance, pricing, or availability, contact:

Steve Simpson
Joint Specialists Inc.
Phone: 936-321-3333
Email: steve@jsicoatings.com
Website: www.heatshrinksleeves.com

Joint Specialists Inc. — Providing pipeline corrosion prevention solutions since 1995.

Comments