
A tee or bend should not be estimated as if it were only a length of straight pipe. Branches, inside radii, weld profiles, and closely spaced fittings change the shape the coating system must cover.
Start with a sketch and photographs
Label the pipe sizes, branch arrangement, and intended coating limits. Show the back side of the fitting and any nearby support or wall that restricts access. A straight-on photograph can hide the very areas that make the application difficult.
Measure the actual surfaces to be treated and identify existing coating that will remain. Separate the straightforward cylindrical areas from the irregular transitions so the material estimate can be checked in sections.
Consider conformity and outer protection together
STOPAQ materials can be considered for irregular structures, but the selected system still needs a continuous corrosion prevention layer and appropriate protection for its exposure. Determine which filler or shaping details are required by the approved application method before calculating wrapping quantities.
- Identify the service temperature and exposure.
- Show each branch and change in diameter.
- Describe the substrate and retained coating.
- Include the specified outer protection and terminations.
Access can control the work
Check whether an applicator can reach the full circumference and inspect the finished coverage. If insulation, clamps, or supports must be addressed, include those steps in the maintenance plan rather than leaving them outside the coating scope.
See JSI's STOPAQ product information. Send the sketch, dimensions, and photographs when requesting material assistance for a tee, bend, or other irregular structure.
Contact Joint Specialists Inc.
For product selection assistance, pricing, or availability, contact:
Steve Simpson
Joint Specialists Inc.
Phone: 936-321-3333
Email: steve@jsicoatings.com
Website: www.heatshrinksleeves.com
Joint Specialists Inc. — Providing pipeline corrosion prevention solutions since 1995.
Comments
Post a Comment