
Covalence Waterwrap sleeve width is selected from the joint area that needs coverage, the required overlap onto the factory coating, and allowance for width shrinkage during installation. Pipe diameter alone does not determine the correct width.
Keeping width and cut length separate makes a quotation clearer. Width runs along the pipe axis across the joint. Cut length runs around the pipe circumference and must suit the selected sleeve configuration and closure.
Measure the exposed joint area
Record the distance between the factory coating edges and describe the joint geometry. Include any offset, step, or irregularity that affects the area to be covered. Send the joint drawing when available.
Use dimensions from the actual project rather than assuming that every pipe supplier uses the same coating cutback. A change in joint details can change the sleeve requirement even if the pipe outside diameter remains the same.
Allow for coating overlap and width shrinkage
The Waterwrap data sheet calls for at least 2 inches of overlap onto the mill-applied coating on each side of the joint. It also directs the buyer to allow for 5% sleeve-width shrinkage during installation when calculating the minimum width.
Check those product requirements against the project specification. Confirm the selected supplied width and its expected installed coverage before ordering. Avoid choosing a size that only just covers the bare steel before shrinking.
Send these details with your inquiry
- Actual pipe outside diameter and factory coating type.
- Exposed joint width and a drawing of the joint profile.
- Required overlap and the specified Waterwrap construction.
- Quantity of joints and whether sleeves or roll material are requested.
- Any project-specific closure or installation requirements.
Does a wider sleeve solve every joint detail?
No. Width selection addresses coverage. Irregular geometry, coating steps, closure selection, and installation procedure still need review. The manufacturer directs users to its application table and installation guidelines for the complete selection and installation details.
Review the manufacturer's Waterwrap documentation, then contact Joint Specialists Inc. with your joint dimensions for sizing assistance, pricing, and availability.
Contact Joint Specialists Inc.
For product selection assistance, pricing, or availability, contact:
Steve Simpson
Joint Specialists Inc.
Phone: 936-321-3333
Email: steve@jsicoatings.com
Website: www.heatshrinksleeves.com
Joint Specialists Inc. — Providing pipeline corrosion prevention solutions since 1995.
Comments
Post a Comment