Anode Splice Encapsulation Shrink Sleeve Kit Install Instructions
Preparing the Cable:
Install connector. Note maximum length of stripped wire leads. Wipe off excess contact compound.
Position tie wrap(s) as shown. Two are required for "H" connections. Note: 1/8 inch gap produced for adhesive encapsulation.
Wrap insulation strip or tape centered on connection. If required, heat strip end slightly to tack in place.
Position Sleeve:
Position sleeve closure over main cable run.
Slide channel onto sleeve rails.
Channel ends should extend evenly beyond ends of sleeve.
Heat-shrink assembly:
Using yellow tip of torch flame, apply heat in a uniform back and forth motion, giving special emphasis to rail/channel area.
Apply heat until all indicator paint changes color. Adhesive will extrude from sleeve ends
A few minutes cooling may be required for complete encapsulation to occur between cables.
